Oh man, you should have seen me looking for the HDMI ports. I was very confused until I realized my mistake. Turns out that there’s more than one kind, who knew🤷
I’ll have to give that camera connection a second look lol
Oh man, you should have seen me looking for the HDMI ports. I was very confused until I realized my mistake. Turns out that there’s more than one kind, who knew🤷
I’ll have to give that camera connection a second look lol
I just picked up a pi4 b today and was tinkering with octoprint.
So far it looks great, i just haven’t figured out how to get the pi camera module 3 working quite yet. The stream from octoprint just constantly tries to load.
I’m excited to try some prints with it soon!
No, that’s a new one.
Would greasing my gantry screw help?
If I’m missing steps due to heat is the only solution a new motherboard?
I thought so too! I cleaned it up a bit and glued the bottom back on. Its my pencil cup at work now
I have! This printer actually finished a 3ft sailboat rudder before this print. I popped some pictures of it in as well
Do you think that could be be solved by adjusting the z offset?
Thanks for the tip! I’ve been hesitant to start messing around to much but I think it should if it means it’s more reliable
I’ve been looking at this for a while. The camera I have on it is a security camera that i put on my desk while it prints if I’m gone.
Do you think its worth pulling the trigger on a raspberry pie to get this set up?
It would at least once lol
Yes, I just finished printing a rudder core for my sailboat.
For all the headache its caused, its also saved me from several trips to the store to find cable ties, chip clips, a hair dryer holder, pencil cups, spice racks, etc.
Sweet thank you!
How’s Freecad these days? I avoided awhile ago it because it looked difficult to use but I think this might push me over to it
Thank you, i’ll do some digging!