Music assistant on home assistant or without HA will let you host your own music but also allow for the addition of streaming providers. It lets you cast your collection to pretty much any speakers. You can even build your own cast receivers with any android device and squeeze cast.
And here I am over here just using telegram for it’s easy to build bots and talking to my family. The boys are handy for many things.
Do these come flat packed is that what the tool is for or do you form the whole thing first then use the tool to bend?
Looks like a partial clog and too fast at the same time. A .8 nozzle lets a lot of material flow, try slowing down after checking for a clog.
Oh and are you skipping steps?
What about the counties where you end up dead well before you can be put behind bars.
Disappointing, was looking forward to affordable SLS. Formlabs is just snatching them up because they hate competition.
That’s nifty but I would have gone with recessed buttons those look painful to tap with the sharp corners.
I prefer Resin scent
Wiggle the nozzle is there any slop?
There is a setting in super slicer called Seam gap, do you see a setting like that you can play with?
deleted by creator
As soon as men try to organize and speak out we get called sexist. If men wanted to start a men only club like women are allowed they would be forced to let women in. Just look at the boy scouts (ignoring the pedophiles) they were forced to allow girls but the girl scouts don’t have to allow boys. Males can’t have anything male only.
Well Kathy needs to get out of the men’s room then, she can wait until I’m done peeing to have a chat.
I use fdm prints for food all the time. Just use once and throw away. As long as you use steel nozzle I think it’s fine no lead dangers.
Alec Baldwin killed it
I got it, Celebrity Endorsement. Like John Oliver.
Just a few Ender 3
Bought some post caps at Home Depot, gutted them, and added a d1 mini + 8x8 led matrix. 
Maybe but it looks like the highest point of the pumpkin flesh is higher than the lowest point of the stem so it wouldn’t look as good. This way is much less waste and faster because you can print all the stems at once.