faebudo@infosec.pubto3DPrinting@lemmy.world•I design and 3D Printed the smallest friction hing, I think is possible at 10mmEnglish
5·
3 months agoYou might be able to make it much stiffer by adding more of the arms parallel. The force should be consistent when you tighten multiple of them with one screw.
It looks like there are multiple layers printed without feeding filament, which causes these frays to build up. Could it be that the filament clogs after this layer? Or do you see that filament still properly feeds later? This could happen for example due to heat creep and the filament getting too warm/soft in the extruder to properly feed or you trying to feed too fast.