Aight, I’m a modern Nintendo hater, but the DS lite was so good. It had a great games library, an excellent layout that didn’t cramp my hands as a child or an adult, and a solid touch screen. Peer to peer networking was so nice in an era where you very rarely had internet anywhere and it was never fast enough for gaming.

I think I must’ve spent hours in pitcochat alone. Plus, my almost 20 year old DS lite still works. I used it to play some of the Layton games just recently! I did manage to break one, but that was cause my mother put some obnoxiously large case on it that made it impossible to play anything. Tried ripping it off and tore the sections in half

Obsidian is just sooooo good. I hate that you (technically 😉) have to pay for multi device sync, but the UI and UX are excellent, especially if you’re already proficient in markdown

Haven’t tried logseq before, so I can’t compare

removed, am I about to become a newgrounds user again after like 15 years?

Are there any programs that can do e2e in a group chat? My limited knowledge of e2e and encryption makes me think that’d be extremely difficult and even clunkier

Oh, might give that a shot real quick! Thank you!

I’m seeing a few filament guides for the ender 3 on thingiverse. Would you recommend either of these?

https://www.thingiverse.com/thing:2920344

https://www.thingiverse.com/thing:2917932

The Nozzle’s recently been changed from one I managed to completely clog, as well as having been thoroughly cleaned. When I got this thing up and running again, I did everything shy of a complete reassembly for cleaning. I’m not sure about the crushed tip part. I’ve long since lost the needle that came with the printer, but I can run out to Walmart tomorrow and grab a new one to check.

I’m also just using these bottlecaps as markers that only I’ll be able to see, so their overall quality isn’t super important, I just want to improve future prints, and this lets me test out text quality. Figured I’d just knock out 2 birds with one stone!

Thanks for the feedback!

I’m testing the bottle caps on 110% extrusion right now. Hopefully that’ll solve the issue, cause I have no idea how to go about following that guide on my ender 3. It just says “use the web interface”, which my cheap af ender 3 doesn’t have

I’m reprint the bottom 2 caps now using the profile I did the bottom left in, but now with 110% extrusion! Wish me luck!

So despite having this printer for a while, I’m unsure of what a few things you’ve asked.

First, the stuff I know how to answer:

• afaik, it’s regular PLA. I bought it second hand but still fully sealed in the vacuum bag, so I’m not 1000% sure, but it only says PLA.
• I unclogged the nozzle within the last couple of weeks with a cold pull. It was having issues with text before and after the unclogging.
• The width seems unlikely. This problem has persisted through 2 filament brands. Unfortunately I don’t have calipers to test that with at the moment.
• The settings I used for the bigger bottlecap (the one split into 2 pieces) were the default "0.08 mm SUPERDETAIL (0.4mm Nozzle) @ CREALITY found on PrusaSlicer. The bottom left cap used a semi-custom version of the same profile where I knocked the speed down to half. Figured it might have been too slow since the text came out way worse than the bottom right, which was printed on the “0.12 mm DETAIL” preset. If you don’t have access to PrusaSlicer, I’d be happy to copy over some of the settings.
• Looking through PrusaSlicer, I don’t see any settings for flow speed other than Bridge Flow Speed, but I will get to googling and find it.

The main thing I don’t understand is calibrating e-steps. I’m unsure of what an e-step is.

Thanks for the quick (and detailed!) reply!