Hi, I have printed a small holder for a Bowden tube to print from my filament dryer outside of the enclosure, but the filament coming out of the tube is tensioned and I don’t know if it will cause problems later. Is this fine to keep or how can I fix this? This i a Ender 3 V3 SE btw.

  • papalonian@lemmy.worldEnglish
    1·
    2 months ago

    Re: dry. I’m convinced PLA doesn’t care about moisture. Watched a video of a guy that soaked a roll in a tub of water overnight, then printed off the roll with it still in the tub. Looked exactly the same as it did before the soak.

    Mileage may vary of course but ever since then I’ve been leaving my PLA out and it’s never once given me trouble (the infused ones a little bit).

    • Boomkop3@reddthat.comEnglish
      1·
      2 months ago

      I’ve had filament sit for months before it started getting brittle. But it does get very brittle. At least the stuff I have bought so far has